Mon, 25 May 2026 12:53:39 +0100 https://www.greenbuildingforum.co.uk/newforum/ Lussumo Vanilla 1.0.3 https://www.greenbuildingforum.co.uk/newforum/comments.php?DiscussionID=1716&Focus=20568#Comment_20568 https://www.greenbuildingforum.co.uk/newforum/comments.php?DiscussionID=1716&Focus=20568#Comment_20568 Tue, 13 May 2008 19:09:59 +0100 vikas_mathew Now a days when the engine is running, the output voltage from it, even in the volatge setting voltmeter also drops to below 50V for a second or two and comes back. the engine is still steady. what could be a possible reason?]]> https://www.greenbuildingforum.co.uk/newforum/comments.php?DiscussionID=1716&Focus=20574#Comment_20574 https://www.greenbuildingforum.co.uk/newforum/comments.php?DiscussionID=1716&Focus=20574#Comment_20574 Tue, 13 May 2008 20:00:34 +0100 chuckey So one good thing to check is that the brushes are good and move freely and the slip rings are in a good state. After that the voltage stabilizer must be looked at. There are many sorts, but there will be some sort of detector that checks the output voltage(s), the signal from this will then alter the DC current throught the armature coil. So just checking connections and relay contacts may find the fault. FWIW low output voltage = low DC current!
Frank]]>